PRE-THINNED PLASTI DIP UV.

Pre-thinned Plasti Dip is ready for spraying.  Wipe surface with alcohol prior to applying Plasti Dip to ensure surface is clean. DO NOT USE PREPSOL.   Stir frequently whilst spraying to stop separation of Plasti Dip and Thinners.  We recommend 5-7 thin spray coats as Plasti Dip is air cured and will not dry if applied too thickly.

Customers are using this product to coat their wheel rims using the Preval Cordless Spray Unit or their own spray gun.  We recommend 5-7 coats of Plasti Dip to get good coverage, this will make the Plasti Dip easier to peel off if/when required. You can download the Technical Data Sheet below for technical information and usage instructions.

Removable from hard, non-porous surfaces when no longer required and will not damage existing paint

Pre-thinned Plasti Dip is ready for spraying.  Wash with warm water and dishwashing liquid.  Wipe surface with alcohol prior to applying Plasti Dip to ensure surface is clean.  DO NOT USE PREPSOL.  Stir frequently whilst spraying to stop separation of Plasti Dip and Thinners.

AVERAGE USAGE: 

2 x 3.78 litre cans to spray the small vehicle.

3 x 3.78 litre cans for a medium vehicle

and 4 x 3.78 litre for a large vehicle

4-5 x 3.78 litres for a larger SUV/4WD

(There are many variables in the usage, ie: what colour you are applying and what colour you are applying over, how much overspray, weather conditions, etc. and the usage is a guide only. If you are putting a light coloured Plasti Dip  over a dark coloured vehicle you will probably use more)

We cannot anticipate all conditions under which this information and our products, or the products of other manufacturers in combination with our products, may be used. We accept no responsibility for results obtained by the applications of this information or the safety and suitability of our products, either alone or in combination with other product combinations for their own purposes. Unless otherwise agreed in writing, we sell the products without warranty, and buyers and users assume all responsibility and liability for loss or damage arising from the handling and use of our products whether used alone or in combination with other products. Ever changing V.O.C. regulations in your area may require you to contact local authorities for proper use and/or disposal of this product. Should you need further assistance, please contact PLASTIC DIPS & COATINGS technical service.  sales@plastidip.net.au

PLASTI DIP, HCF eccs, Performix and logo are registered trademarks of PLASTI DIP INTERNATIONAL